Beautiful Crochet I-cord Flower Pattern For Your Next Project

Let's play with yarn and a crochet hook to bring a burst of cheer into the room! Picture this: you're winding and twirling, and whoosh out pops an adorable Crochet I-cord Flower! These little gems are pure fun to make and even more delightful to share.

Crochet I-cord Flower

Save

Materials Needed:

• Yarn in two colors
• A crochet hook of 2.5 mm
• A paper clip
• Yarn needle
• Scissors

Step-by-Step Pattern:

Save

Making the I-Cord

Prepare the Yarn:

• Double your yarn to the desired length, approximately 105 cm.
• Create a slip knot in the middle of the doubled yarn.

Start Crocheting the I-Cord:

• Perform the following steps to create a double chain I cord:
• Yarn over and pull through both loops.
• Repeat the yarn over and pulling through.
• Continue making the I cord until it reaches the full length of your yarn, about 29 cm.

Finish the I-Cord:

• Pull one end through the loop and tie a knot to secure and cut the yarn.

Creating the Flower

Save

Prepare for Flower Creation:

• Use the yarn needle and the I cord you made.

Forming Petals:

• Insert the needle through the I cord, forming five petals for the flower.
• Join both ends of the I cord to complete the flower structure.

Second Smaller Flower:

• Create another I cord, this time about 25 cm long.
• Follow the same method as above to form a second, slightly smaller flower.

Making the Center Circles

Save

Crochet the Circles:

• Begin with a slip knot, then chain 3.
• Join into a ring with a slip stitch.
• Chain 1 (this counts as a single crochet).
• Make 16 single crochets into the ring.
• Finish the round and cut the yarn.

Attach the Circles:

• Use a yarn needle to sew the circles onto the top center of the prepared flowers with simple stitches.

Covering the Pen

Save

Start Covering the Pen:

• Attach the yarn to the top of the pen.
• Wrap the yarn around the pen in knots from the top to the bottom to fully cover it.

Securing the Yarn:

• Tie a knot at the bottom after fully covering the pen and then cut off any excess yarn.

Attaching the Flower

Sewing the Flower:

• Use the yarn needle to sew the flower onto the top of the covered pen.

Completion

Finish the Project:

• Repeat the process for the second flower if desired.
• Ensure both flowers are securely attached.

Final Look:

• Review the pen to ensure all parts are secure and neatly done.
• Your patterned and flower-topped pen is now ready, making it perfect for a gift or personal use!